3축 가속도센서 -ADXL314
(ACCEL 29 CLICK)
개요
- 본 제품은 3축 가속도센서 -ADXL314 입니다.
- ADXL314 칩을 장착하고 있으며, ±200g 가속도를 측정할 수 있습니다.
- SPI, I2C 인터페이스를 지원하며, 32 레벨 FIFO 버퍼를 가지고 있습니다.
특징
-
HOW DOES IT WORK?
Accel 29 Click is based on the ADXL314, a complete three-axis ±200g acceleration measurement system from Analog Devices, operating at low power levels. The ADXL314 measures both dynamic accelerations resulting from motion or shock and static accelerations, such as gravity. It provides digital output data formatted as 16-bit, with acceleration reported digitally through a configurable and selectable serial interface. The ADXL314 automatically modulates its power consumption proportionately to its output data rate. If additional power savings are desired, it also offers lower power modes, enabling intelligent motion-based power management with threshold sensing and active acceleration measurement at low power dissipation.
The ADXL314 is based on a polysilicon surface-micromachined structure built on top of a silicon wafer that suspends the structure over the surface of the wafer, providing resistance against forces due to applied acceleration. Deflection of the structure is measured using differential capacitors that consist of independent fixed plates and plates attached to the moving mass. Acceleration deflects the proof mass and unbalances the differential capacitor, producing a sensor output whose amplitude is proportional to acceleration. Phase-sensitive demodulation is used to determine the magnitude and polarity of the acceleration.
As mentioned, the acceleration data is accessed through I2C or SPI interface with a maximum frequency of 400kHz for I2C and 5MHz for SPI communication. The selection is made by positioning SMD jumpers labeled COMM SEL appropriately. Note that all the jumpers' positions must be on the same side, or the Click board™ may become unresponsive. While the I2C interface is selected, the ADXL314 allows choosing the least significant bit (LSB) of its I2C slave address using the SMD jumper labeled ADDR SEL.
This board also possesses two interrupts, IT1 and IT2, routed to, where by default, the AN and IT pins stand on the mikroBUS™ socket, entirely programmed by the user through a serial interface. They signal MCU that a motion event has been sensed.
This Click board™ can only be operated with a 3.3V logic voltage level. The board must perform appropriate logic voltage level conversion before using MCUs with different logic levels. However, the Click board™ comes equipped with a library containing functions and an example code that can be used as a reference for further development.
SPECIFICATIONS
Type Motion Applications Can be used for multiple applications such as motion-activated functions, shock detection, high-force event detection, and more On-board modules ADXL314 - three-axis accelerometer from Analog Devices Key Features ±200g measurement range, low power consumption, user-selectable bandwidth, fixed 13-bit output resolution, selectable interface, embedded memory management system with FIFO technology, interrupt, and more Interface I2C,SPI Compatibility mikroBUS Click board size S (28.6 x 25.4 mm) Input Voltage 3.3V