수량을 선택해주세요.
6채널 무선 스위치 Tx/Rx 모듈 키트 -2.4Ghz
(6 Channel Wireless Switch Tx/Rx Kit -2.4Ghz)
개요
- 본 제품은 6채널 무선 스위치 Tx/Rx 모듈 키트 -2.4Ghz입니다.
- 2.4Ghz를 이용하는 6채널 무선 송수신 모듈로 구성되어 있는 제품입니다.
- 모듈에는 MCU가 장착되어 있어 송수신 모듈간 인코딩/디코딩, 페어링 절차를 수행할 수 있습니다.
- 한번 페이링 절차를 마치면 추가로 페어링을 할 필요가 없습니다.
- 6채널로 각각에 채널에 신호를 줄수 있는 버튼을 장착하고 있습니다.
- 스위치 출력을 latch나 momentary로 설정할 수 있는 스위치가 장착되어 있습니다.
특징
- About Wireless Switch TX (will be abbreviated as TX module below):
- - Switch number of channels: 6 channels
- Input ports: 6-channel key input, active low
- Working voltage: 2.5 - 3.6VDC
- Working Current: 0 - 15mA
- Working frequency: 2.4GHz
- MAX Transmission distance: 80 meters (open area)
- D1 LED: Each time you press the button will light up a time
- PAIR button: for pairing
- K1 ~ K6 buttons: Used to control 6 outputs of RX module, active low level
- Antenna: Built-in PCB antenna
- About Wireless Switch RX ((will be abbreviated as RX module below):
- - Switch number of channels: 6 channels
- Output port current: 2mA (max)
- Output mode: latch mode or non-latch mode
- Working voltage: 2.5 - 3.6VDC
- Exact Working frequency: 2.4GHz
- Working Current: 23mA
- Sensitivity: -85db
- PAIR button: for pairing
- Toggle switch on the board: used to switch the output mode, LATCH is the latch mode (only press the button to change the output level), NON-LATCH is non-latch mode (press the button light will be on, and release the button, the LED of RX module light goes off after 350 milliseconds)
- D1 ~ D6: Output LED, active high level output
- Antenna: Built-in PCB antenna
- Great for DIY
문서
- resource
- Pairing Process:
Step1: Power up for the two modules. Press and release the PAIR button of RX module, then D6 LED is on (tells it enters the pairing state). Press and release the PAIR button of TX module within 10 seconds, then the D6 LED flashes for a while and keep the light on.
It is also possible to pairing this RX module with more TX modules (up to a total of 20).
Step2: Wait until D6 LED is off. You can press the K1~K6 button of TX module to test.
You can push the toggle switch on RX module to learn the difference between LATCH and NON-LATCH output mode.
NOTE: A transmitter module can be paired with multiple receiver modules, and one receiver module can only be paired with 20 transmitter modules.
Dimensions:
연관제품
- 연관제품 1
