아두이노 ESP32 WiFi 에어리프트 쉴드
(Adafruit AirLift Shield - ESP32 WiFi Co-Processor)
개요
- 본 제품은 ESP32 WiFi 칩을 장착한 에어리프트 쉴드입니다.
- 아두이노 및 호환 보드와 결합하여 WiFi를 사용할 수 있습니다.
- ESP32 칩을 장착하고 있으며, 레벨 변환 회로, 3.3V 레귤레이터를 포함하며, MOSI를 위한 tri-state chip을 장착하고 있어 SPI 버스를 다른 장치와 공유할 수 있습니다.
- micro SD 카드 소켓이 있어 데이터를 호스트하거나 데이터를 저장하는데 사용할 수 있습니다.
- 아두이노 우노와 같은 Atmega328기반의 아두이노는 부족한 RAM으로 WiFi 및 SD 라이브러리를 동시에 사용할 수 없습니다. 아두이노 M0 혹은 M4 칩을 가진 제품을 추천합니다.
특징
-
Product Dimensions: 68.6mm x 53.4mm x 4.8mm / 2.7" x 2.1" x 0.2"
Product Weight: 14.2g / 0.5oz
문서
- Primary Guide: Adafruit AirLift Shield - ESP32 WiFi Co-Processor
- Comes fully assembled and tested, pre-programmed with ESP32 SPI WiFi co-processor firmware that you can use in CircuitPython to use this into WiFi co-processor. We also include some header so you can solder it in and plug right into your Arduino-compatible, but you can also pick up a set of stacking headers to stack above/below your board.
We've tested this with all our Metros and it should work just fine with them except the Metro M4 Airlifts (cause they already have WiFi!). For use in Arduino, the '328 and '32u4 you can do basic connectivity and data transfer but they do not have a lot of RAM so we don't recommend them - use the Metro M0, M4 or similar, for best results! For CircuitPython use, a Metro M4 works best - the M0 series does not have enough RAM in CircuitPython.
The firmware on board is a slight variant of the Arduino WiFiNINA core, which works great! At this time connection to Enterprise WiFi is not yet supported.