1.3 인치 SPI 컬러 LCD 모듈 -240x240
(1.3 inch SPI Colour LCD (240x240) Breakout -pimoroni)
개요
- 본 제품은 1.3인치 정사각형 모양의 컬러 LCD입니다.
- 240x240 픽셀을 가지고 있는 제품으로 라즈베리 파이나 아두이노에 연결하여 사용이 가능합니다.
- 정사각형 모양으로 데이터 정보나, 그래픽, 혹은 아트 앨범이나 사진 등의 디스플레이도 가능합니다.
- IPS 디스플레이로 좋은 화각과 선명하고 밝은 화질을 가지고 있습니다.
- SPI 인터페이스로 동작하며, 최대 50fps로까지 동작이 가능합니다.
- Breakout Garden HAT with SPI 보드와 사용하면 납땜 없이 라즈베리와 사용이 가능합니다.
특징
- 1.3" colour LCD (240x240 pixels)
- SPI interface
- 3.3V or 5V compatible
- Reverse polarity protection
- Compatible with all models of Raspberry Pi and Arduino
- Python library
-
Display specifications
- 240x240 pixels (~260 PPI)
- 23.4x23.4mm active area
- 250m2 luminance
- 800:1 contrast ratio
- 160° viewing angle (horizontal and vertical)
- ST7789V driver chip
문서
-
Software
We've adapted an existing Python library to drive this display. The library makes it straightforward to display images, text or graphics, and even display animated GIFs!
Connecting to your Raspberry Pi
If you're not using our Breakout Garden HAT with SPI, then this is how to connect your LCD Breakout up to your Raspberry Pi.
Our library is set up to use SPI 0 on the Pi (BCM 8 for CS, BCM 11 for SCK, and BCM 10 for MOSI), BCM 9 for DC, and BCM 18 for the backlight.
Here's which pins to connect between your 1.3" LCD Breakout and your Pi's GPIO (note that it's BCM pin numbering):
- 3-5V to any 5V or 3V pin
- CS to BCM 8
- SCK to BCM 11
- MOSI to BCM 10
- DC to BCM 9
- BL to BCM 18
- GND to any ground pin
You can of course use other pins with your LCD Breakout, but you'll have to change them accordingly when you instantiate the display in your code.
Notes
Dimensions: 41.2x26.6x5.5mm