MicroMod 메인 보드 -베이스보드, 싱글
(SparkFun MicroMod Main Board - Single)
개요
- 본 제품은 MicroMod 메인 보드 -베이스보드, 싱글입니다.
- MicroMod 프로세서와 한 개의 MicroMod Function 보드와 인터페이스 할 수 있는 베이스 보드입니다.
- USB-C 커넥터를 장착하고 있으며, 전원 공급과 프로그래밍시 사용이 가능합니다..
- 2A resettable fuse, 3.3V/1A 전압 레귤레이터를 지원합니다.
특징
- Input Voltage Range
- 5V via USB C Connector
- ~3.7V to 4.2V via LiPo Battery Connector
- Built-in Resettable PTC Fuse (Rated 5V/2A)
- AP7361C 3.3V Voltage Regulator (Rated 1A)
- Integrated MCP73831 Single Cell LiPo Charge Circuit
- Adjustable Charge Rates via DIP Switch
- 100mA
- 166mA
- 500mA
- Adjustable Charge Rates via DIP Switch
- Ports
- 1x USB Type C Connector
- 1x 2-Pin JST Connector
- M.2 Connectors
- 1x MicroMod Processor Board
- 1x MicroMod Function Board
- 2x Qwiic Enabled I2C
- 1x MicroSD Card Socket
- 1x SWD 2x5 Header
- Buttons
- 1x Reset
- 1x Boot
- LEDs
- 1x VIN
- 1x 3.3V
- 1x CHG
- Jumpers
- MEAS
- PTC
- 3.3V EN
- VIN LED
- 3.3V LED
- include
- 1x MicroMod Main Board - Single
- 3x Phillips #0 M2.5x3mm Screws
-
The MicroMod Main Board is a specialized carrier board that allows you to interface a MicroMod Processor Board with a single MicroMod Function Board. With the M.2 MicroMod connector, connecting your Processor and Function Boards is a breeze. Simply match up the key on your board's beveled edge connector to the key on the M.2 connector and secure the boards with screws.
The Single Main Board includes one USB-C connector for power and programming the Processor Board. Two buttons for reset and boot are also populated on the board. Also included on the board is a 2A resettable fuse and 3.3V/1A voltage regulator. We've even added a convenient jumper for advanced users looking to bypass the fuse and another to measure the current consumption for low power testing. For those that need to go remote with their application, the board includes a 2-pin JST connector and a single cell LiPo MCP73831 charge IC (set to a rate of 500mA). Three status LEDs are available for power and charging. There is a microSD card socket so you can also plug in a microSD card for data logging. Finally, two Qwiic connectors are populated on the board to easily add Qwiic enabled I2C devices to your projects!
Note: A MicroMod Processor and Function Board are not included with the MicroMod Main Board. These boards will need to be purchased separately.
문서
-
Hardware Documentation:
MicroMod Documentation: