피더 M0 WiFi 모듈 -ATSAMD21 + ATWINC1500
(Adafruit Feather M0 WiFi - ATSAMD21 + ATWINC1500)
개요
- 본 제품은 아두이노와 WiFi 기능을 하나의 보드로 합칩 피더 M0 WiFi 보드입니다.
- ATSAMD21 마이크로컨트롤러, ATWINC1500 WiFi 칩, USB, 배터리 충전 회로를 탑재하고 있습니다.
- 802.11bgn WiFi 네트워크에 접속할 수 있으며, Soft AP, SSL TSL 1.2, WEP, WPA, WPA2를 지원하며, 안정적인 성능을 보여줍니다.
특징
- A highly-capable Cortex M0+ processor with ton more I/O pins, lots of 12-bit ADCs, a 10-bit DAC, 6 total SERCOMs that can each do SPI, I2C or UART (3 are used by the existing interfaces, leaving you 3), plenty of timers, PWMs, DMA, native USB, and more (check out the Datasheet)
- The ATWINC has much lower power usage, about 12mA for the WINC & 10mA for the ATSAMD21 with auto-powermanagement on for the WiFi and no power management for the ARM. With manual power management, you can get the WiFi module to down to ~2mA by putting it to sleep.
- This is compared to the ESP's ~70mA average current draw, and whose deep sleep mode requires a WDT reset.
- We also found that we could stream more reliably (less 'bursty') with the ATWINC, although altogether the ESP has higher throughput.
- You also dont have to 'yield' all the time to the WiFi core, since its a separate chip. You get full reign of the processor and timing
- Measures 2.1" x 0.9" x 0.3" (53.65mm x 23mm x 8mm) without headers soldered in. Note it is 0.1" longer than most Feathers
- Light as a (large?) feather - 6.1 grams
- ATSAMD21G18 @ 48MHz with 3.3V logic/power
- 256KB FLASH, 32KB SRAM, No EEPROM
- 3.3V regulator (AP2112K-3.3) with 600mA peak current output, WiFi can draw 300mA peak during xmit
- USB native support, comes with USB bootloader and serial port debugging
- You also get tons of pins - 20 GPIO pins
- Hardware Serial, hardware I2C, hardware SPI support
- 8 x PWM pins
- 10 x analog inputs
- 1 x analog output
- Built in 200mA lipoly charger with charging status indicator LED
- Pin #13 red LED for general purpose blinking
- Power/enable pin
- 4 mounting holes
- Reset button
- Comes fully assembled and tested, with a USB bootloader that lets you quickly use it with the Arduino IDE. We also toss in some header so you can solder it in and plug into a solderless breadboard. Lipoly battery and MicroUSB cable not included (but we do have lots of options in the shop if you'd like!)
문서
- Check out our tutorial for all sorts of details, including pinouts, power management, Arduino IDE setup and more!
- Using ATSAMD21 SERCOM for more SPI, I2C and Serial ports
- LIGHTSHIP: LED Animation over WiFi
- Adafruit Feather M0 WiFi with ATWINC1500
- Proper Debugging of ATSAMD21 Processors
- Automatic Twitch On-Air Sign