ESP32 HUZZAH32 보드-WiFi/블루투스 BLE
(Adafruit HUZZAH32 – ESP32 Breakout Board)
개요
- 본 제품은 ESP32 칩을 탑재한 HUZZAH32 보드입니다.
- Feather ESP32 보드와 유사하지만 배터리 충전 회로, USB-Serial 회로가 제거된 버전으로 사이즈와 가격을 줄인 버전입니다.
- 프로그래밍을 위해서는 FTDI 케이블과 같은 USB-Serial 컨버터가 필요합니다.
- 코드를 업로드하기 전에 부트로더 모드로 진입하여야 하며, GPIO #0 버튼과 리셋버튼을 누르고 #0을 릴리즈하여 진입할 수 있습니다.
- ESP32는 WiFi 및 블루투스 클래식 및 BLE를 지원하는 칩입니다.
- ESP32 SPI WiFi co-processor firmware가 미리 탑재되어 출고됩니다.
특징
-
Here are specifications from Espressif about the ESP32:
- 240 MHz dual core Tensilica LX6 microcontroller with 600 DMIPS
- Integrated 520 KB SRAM
- Integrated 802.11b/g/n HT40 Wi-Fi transceiver, baseband, stack and LWIP
- Integrated dual mode Bluetooth (classic and BLE)
- 4 MByte flash include in the WROOM32 module
- On-board PCB antenna
- Ultra-low noise analog amplifier
- Hall sensor
- 10x capacitive touch interface
- 32 kHz crystal oscillator
- 3 x UARTs (only two are configured by default in the Feather Arduino IDE support, one UART is used for bootloading/debug)
- 3 x SPI (only one is configured by default in the Feather Arduino IDE support)
- 2 x I2C (only one is configured by default in the Feather Arduino IDE support)
- 12 x ADC input channels
- 2 x I2S Audio
- 2 x DAC
- PWM/timer input/output available on every GPIO pin
- OpenOCD debug interface with 32 kB TRAX buffer
- SDIO master/slave 50 MHz
- SD-card interface support
-
Product Dimensions: 44.0mm x 25.5mm x 4.8mm / 1.7" x 1.0" x 0.2"
Product Weight: 5.8g / 0.2oz
문서
- Adafruit HUZZAH32 – ESP32 Breakout Board
- Comes fully assembled and tested, pre-programmed with ESP32 SPI WiFi co-processor firmware that you can use in CircuitPython to use this into a WiFi co-processsor over SPI + 2 pins.
연관제품
- 연관제품 1