USB UART 모듈 -CP2110
(USB UART 5 CLICK)
개요
- 본 제품은 USB UART 모듈 -CP2110입니다.
- CP2110 칩을 기반으로 디자인된 제품으로 USB 를 통해 시리얼 통신이 가능하게 하여 주는 제품입니다.
- 표준 USB HID 클래스를 사용하여 설치 드라이버가 필요 없으며 모든 UART RS-232 신호 핀 접근이 가능합니다
특징
-
HOW DOES IT WORK?
USB UART 5 Click is based on the CP2110, a single-chip HID USB to UART bridge controller from Silicon Labs. A USB function controller in the CP2110 is a USB 2.0-compliant, full-speed device with an integrated USB transceiver, one-time programmable ROM, and an asynchronous serial data bus (UART) in one compact package. The UART capabilities of the CP2110 include baud rate support from 300 to 1Mbps, hardware flow control, RS-485 support, and GPIO signals that are user-defined for status and control information. The USB function controller manages all data transfers between USB and UART, command requests generated by the USB host controller, and commands for controlling the function of the UARTs and GPIO pins.
The CP2110 uses the standard USB HID device class, natively supported by most operating systems. A custom driver does not need to be installed for this device. In addition, the CP2110 also supports USB Suspend and Resume modes for power management purposes. The CP2110 enters Suspend mode when Suspend signaling is detected on the bus using the SPD pin of the mikroBUS™ socket. Upon entering Suspend mode, the SPD signal is asserted, but it can also be asserted after a reset condition (RST pin) until device configuration during USB Enumeration is complete. SPD pin detects logic high level when the device is in the Suspend state and logic low when the device is in Normal mode, which is also visually indicated via red LED labeled as CONNECTED.
This Click board™ also features 8 GPIO signals, located on unpopulated headers, that are user-defined for status and control information. Four GPIO signals support alternate features, including a configurable clock output (CLK) from 24MHz to 47kHz, RS-485 transceiver control, and TX and RX LED toggle features. Also, the USB UART 5 Click can work in a USB-powered configuration thanks to the ability of the CP2110 to provide adequate power to all its parts with the help of an internal regulator using the USB bus voltage. To select this mode of operation, it is necessary to switch the jumper PWR SEL to the position marked with VBUS.
This Click board™ can only be operated from a 3.3V logic voltage level. Therefore, the board must perform appropriate logic voltage conversion before using MCUs with different logic levels. However, the Click board™ comes equipped with a library containing functions and an example code that can be used as a reference for further development.
SPECIFICATIONS
Type USB Applications Can be used to quickly add a USB 2.0 full-speed compliant UART interface for custom applications On-board modules CP2110 - USB-to-UART bridge controller from Silicon Labs Key Features HID interface USB to UART data transfer, full speed USB 2.0-compliant, standard USB class device that requires no custom driver, Self or USB powered configuration, UART flow control, various data formats and baud rates, RS-485 mode with bus transceiver control, Suspend mode, GPIO interface, and more Interface UART,USB Compatibility mikroBUS Click board size M (42.9 x 25.4 mm) Input Voltage 3.3V or 5V